Wellgate 26XX Series Manual de usuario Pagina 13
- Pagina / 95
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
26xx Technical Manual EN-V108
12
3.2 Network Configuration
The following instructions will explain the configurations for setting up the WAN
port of the 26xx. There are in total three methods of connections: Static IP,
DHCP and PPPoE.
Note: You can retrieve the IP address of the WAN port by keying #126 on the
phone set that is connected to the FXS port of the gateway. You will hear an IVR
announcing the current IP address of the WAN port.
3.2.1 WAN Setting
The table shown below describes the configuration items for 3 connection types
of network (Static IP, DHCP and PPPoE).
- Wellgate 26xx Series 1
- User Manual 1
- 1. Introduction 4
- 1.1 26xx Telephony Gateway 4
- 1.2 Benefits 4
- 1.3 Physical Interface 4
- 1.4 Specification 5
- 1.5 Setting and maintenance 6
- 1.6 Environmental 6
- 2. Appearance 7
- 3.1 Configuration 10
- 3.2 Network Configuration 13
- WAN Setting 15
- 3.2.1.2 WAN Setting --DHCP 19
- 3.2.1.3 WAN Setting --PPPoE 20
- 3.2.2. LAN Setting 21
- LAN Setting 21
- 3.3 General configuration 23
- 3.3.2.1 SIP Setting 25
- 3.3.3 SIP Advanced Setting 28
- 3.3.4 Payload Type Setting 32
- 3.3.5 Line Setting 33
- 3.3.6 Qos Setting 36
- 3.3.7 Speed Dial Setting 38
- 3.3.8 Caller ID Setting 39
- 3.3.9 CDR Setting 41
- 3.3.10 Syslog Setting 43
- 3.4 Advanced Configuration 45
- 3.4.2 SNTP Setting 50
- 3.4.3 Codec Setting 51
- 3.4.4 Voice Setting 53
- 3.4.5 Tone Setting 55
- 3.4.6 Phone Setting 57
- 3.4.7 Digit Manipulation 59
- 3.4.8 Dial Plan 61
- 3.4.9 Call routing Editor 63
- 3.5 Management 65
- 3.5.2 Save-Reload setting 68
- 3.5.3 Voice File 69
- 3.5.4 Upgrade Firmware 70
- 3.5.5 Reset to Default 71
- 3.5.6 Network Status 72
- 3.5.7 Version Info 73
- 3.5.8 Port Status 74
- 3.5.9 Account 75
- 3.6 Rebooting the system 76
- Example1: 77
- Example 2: 83
- Example 3 87
Hampton Bay Nein Benutzerhandbücher
Beginnend mit M
Comentarios a estos manuales